Go Back
A festive table setting features a red plate and square white plate with a reindeer whose antlers are adorned with leaves and red flowers. The plates rest on DIY sheet music charger plates, surrounded by pine branches and red ornaments.
Print Save
5 from 3 votes
Yield: 1 Charger

DIY Charger Plates Using Sheet Music

A full tutorial on how to make DIY Charger Plates in minutes
Prep Time45 minutes
Cost$3

Materials

  • 1 can Spray glue
  • 1 book Sheet music
  • 1 pad Archival ink (Optional) Brown, sepia, or gray tones - To add texture, depth, and shadowing
  • 1 can Mod Podge Matte or satin finish to seal and strengthen the plate
  • 1 small chip brush
  • 1 pair gloves

Instructions

DIY Sheet Music Charger Plates – Quick Steps

  • Wipe plates clean; lightly sand glossy surfaces so the Mod Podge adheres.
  • Tear sheet music into 2" x 4" pieces for the rim.
  • Measure the center circle and cut a matching sheet music piece using a template.
  • Spray the back of each piece with adhesive and layer them around the rim at a slight angle.
  • Press down firmly, wrapping about ½ inch over the edge and onto the back.
  • Spray and apply the circular piece to the center of the plate.
  • (Optional) Distress edges with archival ink or dark wax for a vintage look.
  • Once dry, seal with spray Mod Podge—apply several light coats for protection.